Huawei AR3200 Series - Checking the Configuration; Configuring VLAN Aggregation; Establishing the Configuration Task

By default, the damping time is 0 seconds, indicating that VLAN damping is not performed.
----End
3.5.6 Checking the Configuration
Procedure
Step 1 Run the display interface vlanif [ vlan-id ] command to check information about a VLANIF
interface.
----End
Example
Run the display interface vlanif command to check the IP address of a VLANIF interface.
<Huawei> display interface vlanif
Vlanif5 current state : DOWN
Line protocol current state : DOWN
Description:HUAWEI, AR Series, Vlanif5 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet protocol processing : disabled
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc01-00e1
Current system time: 2011-02-09 19:45:40
Input bandwidth utilization : --
Output bandwidth utilization : --
Vlanif10 current state : DOWN
Line protocol current state : DOWN
Description:HUAWEI, AR Series, Vlanif10 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet Address is 10.10.10.20/24
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc01-00e1
Current system time: 2011-02-09 19:45:40
Input bandwidth utilization : --
Output bandwidth utilization : --
3.6 Configuring VLAN Aggregation
This section describes how to configure VLAN aggregation to minimize IP addresses occupied
by VLANs.
3.6.1 Establishing the Configuration Task
Applicable Environment
When many VLANs are deployed, numerous IP addresses are occupied. VLAN aggregation
helps solve this problem.
As shown in Figure 3-1, multiple VLANs are aggregated into a super-VLAN. The VLANs that
form the super-VLAN are called sub-VLANs, which use the same network segment.
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 3 VLAN Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
92