Huawei AR3200 Series - Adding Member Interfaces to an Eth-Trunk

The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Step 3 Run:
mode manual load-balance
The operation mode of the Eth-Trunk is set to manual load balancing.
By default, an Eth-Trunk works in manual load balancing mode.
If the local device is configured with an Eth-Trunk in manual load balancing mode, configure
the Eth-Trunk in manual load balancing mode on the peer device.
----End
1.3.4 Adding Member Interfaces to an Eth-Trunk
Context
Perform the following steps on the AR3200 to configure member interfaces of an Eth-Trunk.
Procedure
l Configuration in the Eth-Trunk interface view
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
3. Run:
trunkport interface-type { interface-number1 [ to interface-number2 ] }
&<1-8>
Member interfaces are added to the Eth-Trunk.
l Configuration in the member interface view
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
eth-trunk trunk-id
The interface is added to the Eth-Trunk.
When adding an interface to an Eth-Trunk, pay attention to the following points:
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 1 Link Aggregation Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6