Huawei AR3200 Series - Configuring GVRP; Establishing the Configuration Task; Enabling GVRP

NOTE
The AR3200 supports a maximum of 256 dynamic VLANs when using default GARP timers. When the
recommended GARP timer settings are used, the AR3200 supports a maximum of 4094 dynamic VLANs.
GVRP can run only in the instances corresponding to the port-based VLANs. In addition, the ports blocked
by MSTP, cannot send or receive GVRP packets.
5.3 Configuring GVRP
This section describes how to configure the GVRP function.
5.3.1 Establishing the Configuration Task
Applicable Environment
On a complicated Layer 2 network, you can enable interfaces to dynamically join or leave
VLANs by configuring the GVRP function. The GVRP function simplifies VLAN
configuration.
Pre-configuration Tasks
Before configuring the GVRP function, complete the following task:
l Adding the GVRP interfaces to all VLANs
Data Preparation
To configure the GVRP function, you need the following data.
No.
Data
1 (Optional) Registration mode for GVRP interfaces
2 (Optional) Values of the GARP timers
5.3.2 Enabling GVRP
Context
Perform the following steps on the AR3200 to enable GVRP.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
gvrp
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 5 GVRP Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
146