Huawei AR3200 Series - Adding a Trunk Interface to a VLAN

The system view is displayed.
5. Run:
vlan vlan-id
The VLAN view is displayed.
6. Run:
port interface-type { interface-number1 [ to interface-number2 ] }&<1-10>
The access interface is added to the VLAN, which becomes the default VLAN of the
interface.
By default, VLAN 1 is the default VLAN for all interfaces.
l Adding an access interface to a VLAN in the interface view
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
port link-type access
The link type of the interface is set to access.
By default, the link type of an interface is hybrid.
4. Run:
port default vlan vlan-id
The default VLAN of the interface is configured.
By default, VLAN 1 is the default VLAN for all interfaces.
----End
3.4.3 Adding a Trunk Interface to a VLAN
Context
Perform the following steps on the AR3200 to add a trunk interface to a VLAN.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 3 VLAN Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
85