Huawei AR3200 Series - Optional) Limiting the Number of Active Interfaces

NOTE
All Layer 2 Eth-Trunks in the system must use the same load balancing mode. If the load
balancing mode of one Eth-Trunk is changed, all the other Eth-Trunks use the new load
balancing mode.
l Configuring a Layer 3 Eth-Trunk interface
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
3. Run:
load-balance { dst-ip | dst-mac | src-ip | src-mac | src-dst-ip | src-dst-
mac }
The load balancing mode is configured for the Eth-Trunk.
By default, the load balancing mode of a Layer 3 Eth-Trunk is src-dst-ip.
Member interfaces of an Eth-Trunk perform per-flow load balancing. The local end
and the remote end can use different load balancing modes, without affecting each
other.
----End
1.3.6 (Optional) Limiting the Number of Active Interfaces
Context
Perform the following steps on the AR3200 to limit the number of active interfaces.
Procedure
l Setting the maximum number of interfaces that determine bandwidth for an Eth-Trunk
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
3. Run:
max bandwidth-affected-linknumber link-number
The maximum number of interfaces that determine bandwidth for the Eth-Trunk is
set.
By default, the maximum number of interfaces that determine bandwidth for an Eth-
Trunk is 8.
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 1 Link Aggregation Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8