Huawei AR3200 Series - Checking the Configuration; Adding Interfaces to a VLAN; Establishing the Configuration Task

3.3.4 Checking the Configuration
Procedure
Step 1 Run the display vlan [ vlan-id [ verbose ] ] command to check information about a VLAN.
----End
Example
Run the display vlan command to view information about VLANs.
<Huawei> display vlan
* : management-vlan
---------------------
The total number of vlans is : 5
VLAN ID Type Status MAC Learning Broadcast/Multicast/Unicast Property
--------------------------------------------------------------------------------
1 common enable enable forward forward forward default
10 common enable enable forward forward forward default
20 common enable enable forward forward forward default
30 common enable enable forward forward forward default
100 common enable enable forward forward forward default
Run the display vlan vlan-id verbose command to check the description of a VLAN.
<Huawei> display vlan 10 verbose
* : Management-VLAN
---------------------
VLAN ID : 10
VLAN Name :
VLAN Type : Common
Description : VLAN 0010
Status : Enable
Broadcast : Enable
MAC Learning : Enable
Smart MAC Learning : Disable
Current MAC Learning Result : Enable
Statistics : Disable
Property : Default
VLAN State : Up
----------------
Untagged Port: Ethernet2/0/0 Ethernet2/0/4
----------------
Active Untag Port: Ethernet2/0/0 Ethernet2/0/4
-------------------
Interface Physical
Ethernet2/0/0 UP
Ethernet2/0/4 DOWN
3.4 Adding Interfaces to a VLAN
This section describes how to add an access interface, a hybrid interface, or a trunk interface to
a VLAN.
3.4.1 Establishing the Configuration Task
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 3 VLAN Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
83