Prerequisites
The configurations for remote bridging are complete.
Procedure
l Run the display bridge [ bridge-id ] information command to view information about the
bridge group.
l Run the display bridge traffic [ bridge bridge-id | interface interface-type interface-
number ] command to view the traffic statistics on a specified interface in the bridge group.
----End
Example
Run the display bridge [ bridge-id ] information command to view information about bridge
group 1.
[Huawei] display bridge 1 information
Bridge 1 :
Status : Undo Shutdown
Bridging : IP, Others
Routing : -
MAC learning : Enable
interface :total 2 interface(s) in the bridge
GigabitEthernet1/0/0 : Up
GigabitEthernet2/0/0 : Up
Run the display bridge traffic [ bridge bridge-id | interface interface-type interface-number ]
command to view the traffic statistics on bridge group 1.
[Huawei] display bridge traffic bridge 1
Bridge 1 :
Input :
48 total, 0 bpdu, 11 single,
36 multi, 1 broadcast,
Output :
35 total, 0 bpdu, 11 single,
23 multi, 1 broadcast,
2.6 Configuring Remote Bridging Integrated with IP
Routing
Configuring remote bridging integrated with IP routing allows users in different geographical
locations and on different network segments to communicate with each other.
2.6.1 Establishing the Configuration Task
Before configuring remote bridging integrated with IP routing, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the data required for
the configuration. This will help you complete the configuration task quickly and accurately.
Applicable Environment
To allow LAN users in different geographical locations and on different network segments to
communicate with each other, you need to enable remote bridging integrated with IP routing.
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 2 Transparent Bridging Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
52
To Next Page
Loading...
