Huawei AR3200 Series - Maintaining GVRP; Clearing GARP Statistics; Configuration Examples; Example for Configuring GVRP

GVRP statistics on port Ethernet2/0/1
GVRP status : Enabled
GVRP registrations failed : 0
GVRP last PDU origin : 0000-0000-0000
GVRP registration type : Normal
Run the display garp timer interface ethernet 2/0/1 command to view the values of the GARP
timers on Ethernet 2/0/1.
<Huawei> display garp timer interface ethernet 2/0/1
GARP timers on port Ethernet2/0/1
GARP JoinTime : 20 centiseconds
GARP LeaveTime : 60 centiseconds
GARP LeaveAllTime : 1000 centiseconds
GARP HoldTime : 10 centiseconds
5.4 Maintaining GVRP
This section describes how to clear the GARP statistics.
5.4.1 Clearing GARP Statistics
Context
CAUTION
GARP statistics cannot be restored after being cleared.
Procedure
Step 1 Run the reset garp statistics [ interface { interface-type interface-number [ to interface-type
interface-number ] }&<1-5> ] command in the user view to clear GARP statistics on the specified
interfaces.
----End
5.5 Configuration Examples
This section provides a configuration example for GVRP.
5.5.1 Example for Configuring GVRP
Networking Requirements
As shown in Figure 5-2, a branch of Company A communicates with the headquarters through
RouterA and RouterB. To simplify the configuration, you need to enable GVRP on all routers
of Company A and set the registration mode to normal on interfaces.
Company B communicates with Company A through RouterB and RouterC. To configure
Company B's routers to transmit only packets from VLANs specified by Company B, enable
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 5 GVRP Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
150