Huawei AR3200 Series - Enabling the MUX VLAN Function on an Interface; Checking the Configuration

NOTE
vlan-id1 and vlan-id2 are integers that range from 1 to 4094. vlan-id2 must be greater than
vlan-id1.
l Configuring the subordinate separate VLAN
1. Run:
system-view
The system view is displayed.
2. Run:
vlan vlan-id
The principal VLAN view is displayed.
3. Run:
subordinate separate vlan-id
The separate VLAN is configured.
----End
3.7.4 Enabling the MUX VLAN Function on an Interface
Context
Perform the following steps on the AR3200 to enable the MUX VLAN function.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
port mux-vlan enable
The MUX VLAN function is enabled on the interface.
NOTE
l Limiting MAC address learning on an interface may affect the MUX VLAN function on the interface.
l Port security and MUX VLAN cannot be enabled on the same interface.
----End
3.7.5 Checking the Configuration
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 3 VLAN Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
99