Huawei AR3200 Series - Adding Network-Side Interfaces to a Bridge Group

Figure 2-7 Networking diagram for adding users to bridge groups
RouterB
User 5
Network
RouterA
User 1
User 4
User 2 User 3
VLAN 11
Perform the following steps on the user-side interface of the device.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The user-side interface view is displayed.
Step 3 Run:
bridge bridge-id
An interface is added to a bridge group.
A maximum of 20 interfaces can be added to a bridge group. Different types of interfaces can
be added to the same bridge group. Layer 2 interfaces cannot be added to a bridge group.
Ethernet sub-interfaces and GE sub-interfaces configured to terminate QinQ tags do not support
transparent bridging.
----End
2.6.4 Adding Network-side Interfaces to a Bridge Group
Using intermediate links to connect two devices allows different LANs to communicate with
each other.
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 2 Transparent Bridging Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
55