Huawei AR3200 Series - Optional) Disabling a Bridge Group from Bridging Specified Protocol Packets; Checking the Configuration

The bridge group view is displayed.
Step 3 Run:
routing ip
IP routing is enabled for the bridge group.
The IP routing function cannot be configured if any of member interfaces in the bridge group
has an IP address. Before configuring the IP routing function, delete the IP addresses of these
member interfaces.
----End
2.4.6 (Optional) Disabling a Bridge Group from Bridging Specified
Protocol Packets
If a bridge group is disabled from bridging specified protocol packets, the bridge group will
discard the protocol packets.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bridge bridge-id
The bridge group view is displayed.
Step 3 Run:
bridging { ip | others } disable
The bridge group is disabled from bridging specified protocol packets.
To allow a bridge group to forward specified protocol packets, enable the function that bridges
the protocol packets on the bridge group. By default, a bridge group bridges all protocol packets.
----End
2.4.7 Checking the Configuration
After configuring local bridging integrated with IP routing, you can view the traffic statistics on
a bridge group or a specified interface in the bridge group.
Prerequisites
The configurations for local bridging integrated with IP routing are complete.
Procedure
l Run the display interface bridge-if [ bridge-id ] command to check information about the
Bridge-if interface.
l Run the display bridge [ bridge-id ] information command to check information about
the remote bridge group.
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 2 Transparent Bridging Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
44