Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The user-side interface view is displayed.
Step 3 Run:
bridge bridge-id
An interface is added to a bridge group.
A maximum of 20 interfaces can be added to a bridge group. Different types of interfaces can
be added to the same bridge group. Layer 2 interfaces cannot be added to a bridge group.
QinQ termination Ethernet sub-interfaces and QinQ termination GE sub-interfaces do not
support transparent bridging.
----End
2.3.4 (Optional) Disabling a Bridge Group from Bridging Specified
Protocol Packets
If a bridge group is disabled from bridging specified protocol packets, the bridge group will
discard the protocol packets.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bridge bridge-id
The bridge group view is displayed.
Step 3 Run:
bridging { ip | others } disable
The bridge group is disabled from bridging specified protocol packets.
To allow a bridge group to forward specified protocol packets, enable the function that bridges
the protocol packets on the bridge group. By default, a bridge group bridges all protocol packets.
----End
2.3.5 Checking the Configuration
After configuring local bridging, you can view the traffic statistics on a bridge group or a
specified interface in the bridge group.
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 2 Transparent Bridging Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
38
To Next Page
Loading...
