Huawei AR3200 Series - Optional) Disabling a Bridge Group from Bridging Specified Protocol Packets

The MP group interface view is displayed.
4. Run:
link-protocol ppp
PPP is enabled on the interface.
l Add an FR interface to a bridge group.
1. Run:
fr dlci dlci
A frame relay DLCI is created.
2. Run:
bridge bridge-id
The FR interface to the bridge group.
3. Run:
fr map bridge dlci-number broadcast
A mapping between the frame relay DLCI and the bridge group is configured.
l Add an ATM interface to a bridge group.
1. Run:
bridge bridge-id
The ATM interface is added to the bridge group.
2. Run:
pvc { { pvc-name [ vpi/vci ] | vpi/vci } | { start-vpi/start-vci end-vpi/end-
vci } }
A specified PVC is configured to send and receive bridge packets.
3. Run:
map bridge broadcast
A mapping between the ATM PVC and the bridge group is configured.
A maximum of 20 interfaces can be added to a bridge group. Different types of interfaces can
be added to the same bridge group. Layer 2 interfaces cannot be added to a bridge group.
To add an MFR interface to a bridge group, ensure that the FR interfaces bound to the MFR
interface have the same bandwidth; otherwise, packet loss may occur.
----End
2.5.5 (Optional) Disabling a Bridge Group from Bridging Specified
Protocol Packets
If a bridge group is disabled from bridging specified protocol packets, the bridge group will
discard the protocol packets.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bridge bridge-id
The bridge group view is displayed.
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 2 Transparent Bridging Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
50