Huawei AR3200 Series - Checking the Configuration

The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
The vlan-id parameter specifies the ID of the super-VLAN.
Step 3 Run:
arp-proxy inter-sub-vlan-proxy enable
Proxy ARP is enabled between sub-VLANs.
----End
3.6.6 Checking the Configuration
Procedure
l Run the display vlan [ vlan-id [ verbose ] ] command to check information about a VLAN.
l Run the display interface vlanif [ vlan-id ] command to check information about a
VLANIF interface.
l Run the display sub-vlan command to check mappings between sub-VLANs and super-
VLANs.
l Run the display super-vlan command to check sub-VLANs contained in a super-VLAN.
----End
Example
Run the display vlan verbose command to view the VLAN type.
<Huawei> display vlan 2 verbose
* : Management-VLAN
---------------------
VLAN ID : 2
VLAN Name :
VLAN Type : Super
Description : VLAN 0002
Status : Enable
Broadcast : Enable
MAC Learning : Enable
Smart MAC Learning : Disable
Current MAC Learning Result : Enable
Statistics : Disable
Property : Default
VLAN State : Down
---------------
sub-VLAN List: 20
Run the display interface vlanif command to view the physical status, link protocol status, IP
address, and mask of a VLANIF interface.
<Huawei> display interface vlanif 2
Vlanif2 current state : DOWN
Line protocol current state : DOWN
Description:HUAWEI, AR Series, Vlanif2 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet Address is 10.1.1.1/24
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc03-0205
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 3 VLAN Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
96