Huawei AR3200 Series - Assigning an IP Address to the VLANIF Interface of the Super-VLAN; Configuring Proxy ARP for the Super-VLAN

The super-VLAN and sub-VLANs must use different VLAN IDs. A super-VLAN cannot contain
any physical interfaces.
Step 4 Run:
access-vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>
The AR3200 supports 32 sub-VLANs in a super-VLAN.
----End
3.6.4 Assigning an IP Address to the VLANIF Interface of the Super-
VLAN
Context
Perform the following steps on the AR3200 to assign an IP address to the VLANIF interface of
the super-VLAN.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
A VLANIF interface is created and the VLANIF interface view is displayed.
The VLANIF interfaces can be configured only for a super-VLAN. Therefore, vlan-id specifies
the VLAN ID of the super-VLAN.
Step 3 Run:
ip address ip-address { mask | mask-length } [ sub ]
The IP address of the VLANIF interface is configured.
The IP address of the VLANIF interface must be in the same network segment as users in the
sub-VLANs.
----End
3.6.5 Configuring Proxy ARP for the Super-VLAN
Context
Perform the following steps on the AR3200 to configure proxy ARP for the super-VLAN.
Procedure
Step 1 Run:
system-view
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 3 VLAN Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
95