port hybrid pvid vlan vlan-id
The default VLAN of the hybrid interface is specified.
By default, VLAN 1 is the default VLAN of hybrid interfaces.
An interface does not belong to the default VLAN after the default VLAN is specified. To enable
the interface to forward packets of the default VLAN, add the interface to the default VLAN.
----End
3.4.7 Checking the Configuration
Procedure
l Run the display interface [ interface-type [ interface-number ] ] command to check the
PVID of the interface.
l Run the display vlan [ vlan-id ] command to check information about the VLAN.
----End
Example
Run the display interface [ interface-type [ interface-number ] ] command to view the PVID
of an interface.
<Huawei> display interface ethernet 2/0/0
Ethernet2/0/0 current state : DOWN
Line protocol current state : DOWN
Description:HUAWEI, AR Series, Ethernet2/0/0 Interface
Switch Port,PVID : 6, TPID : 8100(Hex), The Maximum Frame Length is 9216
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0018-2000-0083
Last physical up time : -
Last physical down time : 2009-04-19 18:25:51
Port Mode: COMMON FIBER
Speed : 1000, Loopback: NONE
Duplex: FULL, Negotiation: ENABLE
Mdi : NORMAL
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Input peak rate 0 bits/sec,Record time: -
Output peak rate 0 bits/sec,Record time: -
Input: 0 packets, 0 bytes
Unicast: 0, Multicast: 0
Broadcast: 0, Jumbo: 0
Discard: 0, Total Error: 0
CRC: 0, Giants: 0
Jabbers: 0, Throttles: 0
Runts: 0, DropEvents: 0
Alignments: 0, Symbols: 0
Ignoreds: 0, Frames: 0
Output: 0 packets, 0 bytes
Unicast: 0, Multicast: 0
Broadcast: 0, Jumbo: 0
Discard: 0, Total Error: 0
Collisions: 0, ExcessiveCollisions: 0
Late Collisions: 0, Deferreds: 0
Buffers Purged: 0
Input bandwidth utilization threshold : 100.00%
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 3 VLAN Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
88