The integrated routing function uses Bridge-if interfaces for routing packets.
Pre-configuration Tasks
Before configuring remote bridging integrated with IP routing, complete the following task:
l Configuring physical parameters for interfaces to ensure that the interfaces are physically
Up
Data Preparation
To configure remote bridging integrated with IP routing, you need the following data.
No. Data
1 Number of a bridge group
2 Number of an interface added to a bridge group
3 IP address of the Bridge-if interface that represents the bridge group
2.6.2 Creating a Bridge Group
A bridge group is a virtual group. It can forward packets only after interfaces have been added
to the group.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bridge bridge-id
A bridge group is created and the bridge group view is displayed.
If the bridge group specified by bridge-id exists, the bridge group view is displayed.
Multiple devices can use the same bridge number.
----End
Follow-up Procedure
By default, dynamic MAC address learning is enabled for a bridge group. When a network is
insecure and vulnerable to attacks, you can disable dynamic MAC address learning and use static
MAC address entries for traffic forwarding. Perform one or more of the following operations
depending on the type of MAC address entries to be added:
l Configure a static MAC address entry for a bridge group.
– Run:
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 2 Transparent Bridging Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
53
To Next Page
Loading...
