Huawei AR3200 Series - Page 53

l Use a VLAN to add users to the bridge group. Create a VLAN on a bridge and add users
to the VLAN. Users then connect to the bridge group through the VLANIF interface. User
1 and User 2 use this method.
l Use Ethernet sub-interfaces to add users to the bridge group. This method is used when
flows on a physical interface need to be differentiated using sub-interfaces. User 4 uses this
method.
Figure 2-5 Networking diagram for adding users to bridge groups
RouterA
User 3
User 4
VLAN 11
User 1 User 2
Perform the following steps on the user-side interface of the device.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The user-side interface view is displayed.
Step 3 Run:
bridge bridge-id
An interface is added to a bridge group.
A maximum of 20 interfaces can be added to a bridge group. Different types of interfaces can
be added to the same bridge group. Layer 2 interfaces cannot be added to a bridge group.
QinQ termination Ethernet sub-interfaces and QinQ termination GE sub-interfaces do not
support transparent bridging.
----End
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 2 Transparent Bridging Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
42