Huawei AR3200 Series

To Next Page

To Previous Page

Figure 2-8 Networking diagram of local bridging configuration

RouterA

User 2User 1

VLAN 11

User 3 User 4

GE4/0/0

1.1.1.1/24 1.1.1.2/24 1.1.1.4/241.1.1.3/24

Eth2/0/1

GE3/0/0

Eth2/0/2

Configuration Roadmap

The configuration roadmap is as follows:

1. Configure bridge groups.

2. Add User 1 and User 2 to VLAN 11 and then add them to bridge group 1 on VLANIF 11.

Add User 3 to bridge group 1. This allows communication between User 1, User 2, and

User 3.

3. Add User 4 to bridge group 2 to isolate User 4 from User 1, User 2, and User 3.

Data Preparation

To complete the configuration, you need the following data:

l Interfaces used to connect LANs

l Number of each bridge group to which the LANs that need to communicate with each other

are added

l ID of each VLAN of which interfaces are added to a bridge group

Configuration Procedure

1. Create bridge group 1.

<Huawei> system-view

[Huawei] sysname RouterA

[RouterA] bridge 1

[RouterA-bridge1] quit

2. Add Eth2/0/1 and Eth2/0/2 to VLAN 11.

[RouterA] vlan 11

[RouterA-vlan11] quit

[RouterA] interface ethernet 2/0/1

[RouterA-Ethernet2/0/1] port link-type access

[RouterA-Ethernet2/0/1] port default vlan 11

[RouterA-Ethernet2/0/1] quit

[RouterA] interface ethernet 2/0/2

[RouterA-Ethernet2/0/2] port link-type access

[RouterA-Ethernet2/0/2] port default vlan 11

Huawei AR3200 Series Enterprise Routers

Configuration Guide - LAN 2 Transparent Bridging Configuration

Issue 02 (2012-03-30) Huawei Proprietary and Confidential

Huawei AR3200 Series - Page 74