Huawei AR3200 Series - Page 77

Data Preparation
To complete the configuration, you need the following data:
l Interfaces used to connect LANs
l Number of each bridge group to which the LANs that need to communicate with each other
are added
Configuration Procedure
l Configure the IP routing function.
1. Configure RouterA.
# Create bridge group 1 and enable local bridging and IP routing for the bridge group.
<Huawei> system-view
[Huawei] sysname RouterA
[RouterA] bridge 1
[RouterA-bridge1] routing ip
[RouterA-bridge1] quit
# Add Eth2/0/1 and Eth2/0/2 to VLAN 11.
[RouterA] vlan 11
[RouterA-vlan11] quit
[RouterA] interface ethernet 2/0/1
[RouterA-Ethernet2/0/1] port link-type access
[RouterA-Ethernet2/0/1] port default vlan 11
[RouterA-Ethernet2/0/1] quit
[RouterA] interface ethernet 2/0/2
[RouterA-Ethernet2/0/2] port link-type access
[RouterA-Ethernet2/0/2] port default vlan 11
[RouterA-Ethernet2/0/2] quit
#Add VLANIF 11 to bridge group 1.
[RouterA] interface vlanif 11
[RouterA-Vlanif11] bridge 1
[RouterA-Vlanif11] quit
# Configure an IP address for GE3/0/0 on RouterA.
[RouterA] interface gigabitethernet 3/0/0
[RouterA-GigabitEthernet3/0/0] ip address 3.1.1.1 255.255.255.0
[RouterA-GigabitEthernet3/0/0] quit
# Create Bridge-if interface 1 and configure an IP address for it.
[RouterA] interface bridge-if 1
[RouterA-Bridge-if1] ip address 1.1.1.3 255.255.255.0
[RouterA-Bridge-if1] quit
2. Verify the configuration.
# After the preceding configurations are complete, User 1 and User 3 can ping each
other.
Configuration Files
Configuration file of RouterA
#
sysname RouterA
#
bridge 1
routing ip
#
interface Vlanif11
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 2 Transparent Bridging Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
66