Huawei E9000 - Page 112

Figure 6-3 Removing the MM910
3. Completely open the ejector lever on the MM910. See (2) in Figure 6-3.
4. Horizontally pull out the MM910 from the chassis. See (3) in Figure 6-3.
5. Close the ejector lever on the MM910. See (4) in Figure 6-3.
NO TICE
Each ESD bag should hold only one MM910.
6. Place the removed MM910 into an ESD bag.
Step 4 Install a new MM910.
1. Completely open the ejector lever on the MM910. See (1) in Figure 6-4.
Figure 6-4 Installing a new MM910
E9000 Server
User Guide
6 Parts Replacement
Issue 25 (2019-11-30) Copyright © Huawei Technologies Co., Ltd. 102