Figure 6-9 Installing a half-width compute node
c. Completely open the ejector lever on the half-width compute node. See (2) in
Figure 6-9.
d. Horizontally insert the half-width compute node into the chassis. See (3) in
Figure 6-9.
e. Close the ejector lever on the half-width compute node. See (4) in
Figure 6-9.
l Install a full-width compute node.
a. (Optional) Remove the partition board.
Perform this operation only when there is a partition board in the slot where a full-width
compute node is to be installed.
i. Press and hold down the hole and push the partition board inwards. See (1) and
(2) in Figure 6-10.
ii. Move the partition board rightwards and remove it. See (3) and (4) in
Figure 6-10
E9000 Server
User Guide
6 Parts Replacement
Issue 25 (2019-11-30) Copyright © Huawei Technologies Co., Ltd. 108
To Next Page
Loading...
