Procedure
Step 1 Remove a GE network cable or serial cable.
l Before removing cables, record the connection sequence and positions of all the cables on
the switch module to be replaced.
l The cables to a switch module vary depending on the port type. Determine whether to
remove or connect a cable as required.
Figure 6-15 Removing a GE network cable or serial cable
The BMC serial port, SYS serial port, and GE electrical port are standard RJ-45 ports, and cables can be
removed from them in the same way.
Step 2 Remove the optical cable and optical module from a 10GE or 8 Gbit/s FC optical port.
1. Remove the optical cable from the optical module. See (1) and (2) in Figure 6-16.
Figure 6-16 Removing the optical cable
2. Install the dustproof caps for the optical cable. See (3) in Figure 6-16.
The methods for removing an optical cable from a 10GE optical port and an 8 Gbit/s FC optical
port are the same.
E9000 Server
User Guide
6 Parts Replacement
Issue 25 (2019-11-30) Copyright © Huawei Technologies Co., Ltd. 116
To Next Page
Loading...
