l Bind cables on a cable organizer in bundles. Bind the first bundle to the beam of the
cable organizer, and the next bundle to the previous bundle. After the device is installed,
the cross section of the cables fixed on the cable organizer should be rectangular, as
shown in Figure A-9.
Figure A-9 Binding cables (1)
l Lay out and bind cables by color.
l The bending radius (R) must meet the requirements listed in Table A-3.
Table A-3 Bending requirements for signal cables
Cable Type
Bending Radius (R)
Ethernet signal cable R ≥ 2d
Optical cable R ≥ 40 mm (1.57 in.); bending angle > 90°
E9000 Server
User Guide
A Appendix
Issue 25 (2019-11-30) Copyright © Huawei Technologies Co., Ltd. 164
To Next Page
Loading...
