Figure A-17 Moving equipment using a pallet truck (3)
Note the following when moving equipment using a pallet truck:
l Ensure that the passage is clear and wide and high enough for equipment to pass through.
l Move equipment with at least another two persons. One person directs the pallet truck
and the other two hold equipment, as shown in Figure A-15 and Figure A-17.
l Lower the forks of the pallet truck, insert the fork yoke into the middle of the lower
surface of the pallet, and lift the pallet truck.
l Move the pallet truck at a constant speed, and do not stop it suddenly.
l Slow down the pallet truck before making a turn. When making a turn, pull equipment to
move along the outer side of the passage center line (to increase the radius of the turn),
as shown in Figure A-18.
Figure A-18 Route for moving equipment at a turn
l Move equipment along a straight line wherever practical, and ensure that the included
angle of the yoke and the moving direction is greater than or equal to 120°.
E9000 Server
User Guide
A Appendix
Issue 25 (2019-11-30) Copyright © Huawei Technologies Co., Ltd. 172
To Next Page
Loading...
