Figure 3-5 Slot numbers
1E, 2X,
3X, and 4E
Slots for installing switch
modules and pass-through
modules. It is recommended
that pass-through modules be
installed in slots 1E and 4E to
facilitate cable routing.
MM1 and
MM2
Slots for installing
management modules.
PSU 1 to
PSU 6
Slots for installing PSUs. (1) to (14) Slots for installing fan
modules.
ESD jack A jack for inserting the ESD
wrist strap.
PGND Ground terminal.
Step 2 Remove switch modules.
1. Use a Phillips screwdriver to loosen the two M3 captive screws on a switch module. See
(1) in Figure 3-6.
E9000 Server
User Guide
3 Installing the E9000
Issue 25 (2019-11-30) Copyright © Huawei Technologies Co., Ltd. 50
To Next Page
Loading...
