Figure 3-6 Removing a switch module
2. Completely open the two ejector levers on the switch module. See (2) in Figure 3-6.
3. Horizontally pull the switch module out of the chassis slot. See (3) in Figure 3-6.
4. Close the two ejector levers on the switch module. See (4) in Figure 3-6.
Each ESD bag should hold only one management module.
5. Place the removed switch module into an ESD bag.
6. Repeat Step 2.1 to Step 2.5 to remove other switch modules.
Step 3 Remove pass-through modules.
Follow Step 2.1 to Step 2.5 to remove pass-through modules.
Step 4 Remove management modules.
1. Use a Phillips screwdriver to loosen the M3 captive screw on the management module.
See (1) in Figure 3-7.
E9000 Server
User Guide
3 Installing the E9000
Issue 25 (2019-11-30) Copyright © Huawei Technologies Co., Ltd. 51
To Next Page
Loading...
