Figure 8-14 Installing the RF_Z antenna
(1) RF_Z antenna
2. Attach the 4G antenna to the top of the ELV feeder window on the pre-fab.
module.
– After routing the 4G antenna cable into the pre-fab. module through its
ELV feeder window (No. 11), seal the port in the feeder window using
sealing putty.
– The cable outside the pre-fab. module must be
t with a corrugated metal
hose.
– The cable outside the pre-fab. module can be bent only in the U-shape.
FusionDC1000A Prefabricated All-in-One Data
Center
Installation Guide (IT Scenario) 8 Installing Devices Inside the Pre-fab. Module
Issue 01 (2021-04-20) Copyright © Huawei Technologies Co., Ltd. 78
To Next Page
Loading...
