Placing Optical Apparatus and fibers
Do not touch pins or connecting fingers with bare hands. Handle the optical fibers gently. Use
two fingers to hold the fiber connector instead of grasping the fiber or the fiber cover.
Do not apply axial or lateral fiber wallop bumps on the fiber. Do not fold, twist, or crush the
tail fiber. Do not drag the tail fiber or press the coupling point of the tail fiber. Figure 1-112
shows how to properly place optical apparatus and fibers.
Figure 1-112 Methods of placing optical apparatus and fibers
Install the fiber in circles with diameter longer than 6 cm ( 0.20 ft ).
Uninstalling Optical Apparatus
Open the buckle and slowly take out the optical apparatus. Do not drag the optical fiber
to forcibly take out the optical fiber. Ensure that the optical fiber is connected to and
removed from the interface horizontally.
To Next Page
Loading...
