● Do not open the protective covers for the positive and negative terminals of a
battery module at the same time. Close the protective covers for the terminals
where copper bars have been installed.
● After removing the insulation cap from a power cable, install the cable
immediately to prevent the exposed terminal from touching the shell, which
may cause sparks or burns.
● Check that there is no dirt on the surface of copper bars to be connected to the
positive and negative terminals of battery modules. If there is dirt, clean it up
before installing the copper bars.
● Ensure that unused terminals and cables are properly insulated. If an insulation
cap or insulation layer is damaged, repair it promptly.
● To avoid short circuits, do not put tools (such as screwdrivers) into the thread
holes on the positive and negative terminals of the battery module.
● Excessive bolts will be used as spare parts.
● When installing cables, ensure that the cables do not block the QR code on the left of
the protective cover.
SmartLi 3.0
User Manual (Short-Term Backup Power) 5 Installation and Cable Connection
Issue 10 (2024-01-31) Copyright © Huawei Digital Power Technologies Co., Ltd. 92
To Next Page
Loading...
