Huawei SmartLi 3.0 - Page 97

Figure 5-36 Installing battery modules and ller panels (7+7 and 7+0 scenarios)
Figure 5-37 Installing battery modules and ller panels (6+6 and 6+0 scenarios)
Step 3 Open the front cover of a battery module, install the bae plate, and tighten the
two screws. Check the insulation performance of battery modules. Set a
multimeter to the DC voltage mode and measure the voltage between the positive
and negative terminals of each battery module and the screws on the battery
bae plate respectively. If the readings are less than 6 V DC, the insulation is
good. Otherwise, contact technical support engineers.
SmartLi 3.0
User Manual (Short-Term Backup Power) 5 Installation and Cable Connection
Issue 10 (2024-01-31) Copyright © Huawei Digital Power Technologies Co., Ltd. 88