11
3
. Select Normal. Press the RIGHT Cursor key.
NOTE: If you wait too long to select a start-up option, the system will start the mode that is already highlighted. If your control head
goes into Demonstration mode, please note that menu settings cannot be saved in this mode (see Manage your Control Head).
Normal
Normal mode is required for on-the-water operation. If a functioning transducer is connected
to the control head, Normal will be selected automatically, and your control head can be used
o
n the water.
Simulator
To learn how to use your control head, select Simulator. You can save menu settings and
navigation data in Simulator mode (see Chart Overview and Navigation Overview for more
information).
System Status
To view system information for software version, GPS reception, and accessory connections,
select System Status. See Check Accessory Connections and Check GPS Reception for more
information.
Starting Normal Mode for on-the-water Operations
Press the
RIGHT Cursor key
Getting Started
To Next Page
Loading...
Need help?
General
