Page 91
User Guide v 1.0 — August 2018 Altanium Neo5
If the fixed setpoint is enabled, then the entered value is used as the minimum setpoint.
If not enabled, the lowest normal setpoint for the zones that are selected for testing is
used as the minimum setpoint.
All the temperatures for the input sensors that are being tested must be below this limit
before the next zone is tested during the wiring test.
6. On the Fixed Start Setpoint dialog box, enter the temperature, then .
7. To use the fixed setpoint, touch the box to the right of the use Fixed Setpoint button.
This will put a in the box.
8. Touch the box to the right of the Zone Cooling Time button.
9. On the zone cooling time dialog box, enter the zone cooling time, then . Refer to
8.2.1.
10. Touch the box to the right of the maximum test time button.
To Next Page
Loading...
