v 1.0 — August 2018 Altanium Neo5
Page 126
14.1 Configure the Digital I/O
On the Home screen, in the System Configuration row, select Digital I/O.
After you have made the applicable connection, for each input and output being used, select
invert if necessary. Select In Use to turn the input/output on.
Item Description
Active Indicates the logical state of the I/O signal. This displays the final
state of the signal after the optional invert is applied.
Level Indicates the physical (electrical) state of the I/O at the pin. This
state equals the logical state after it is optionally inverted, by a
normally close signal.
Name The name of the input/output.
Invert The input/output signal is true when the signal goes high to low
(versus normal low to high).
In Use A check in the box turns the input/output on.
Pins The connector pins used for the input/output.
To Next Page
Loading...
