Need help?Do you have a question about the Husky Altanium Neo2 and is the answer not in the manual?
General| Thermocouple Types | J, K, T |
|---|---|
| Control Algorithm | PID |
| Input Types | Thermocouple |
| Control Outputs | SSR |
| Communication | Ethernet |
| Display | Touchscreen |
| Operating Temperature | 0°C to 50°C |
| Controller Type | Advanced Temperature Controller |
Covers critical safety warnings related to electrical shock, gas, and vapor hazards.
Explains open loop and closed loop control methods, and thermocouple types.
Explains the two interface modes: Basic and Advanced, and their functionalities.
Details the function of the USB port for file transfer and printing, with important cautions.
Explains how to enter the system password using the numerical keypad interface.
Instructions on how to load a saved mold setup configuration into the system.
Explains how to transfer mold setups to and from a USB disk.
Introduces the Zone Data screen for monitoring and adjusting heater zones.
Covers adjusting setpoints, turning zones on/off, and setting boost/standby parameters.
Covers advanced settings like alarm bands, sensor assignment, and PID control.
Overview of advanced system parameters requiring a security code for access.
Overview of viewing zone alarms and system error logs.
Step-by-step instructions for replacing an Intelligent Control Card.
To Next Page
