Husky Altanium Neo2 - Changing the Standby Cycle; Setting the Delay Boost Timer; Boost Operation Description

v 1.4 — September 2015 Altanium Neo2
76 Changing the Standby Cycle
9.4.2.2.1 Changing the Standby Cycle
To enable or disable the Standby Cycle:
1. On the Home screen, touch Options
2. Touch the Standby Cycle box to toggle the Standby Cycle On or Off.
NOTE:This setting will not appear if the system does not have Remote Standby available.
9.4.2.3 Setting the Delay Boost Timer
The Delay Boost timer is used to wait for a specified period before entering Boost.
To set the delay boost timer:
1. On the Home screen, touch TIMERS.
2. Touch DELAY BOOST TIMER.
3. Enter the new timer value (HH:MM:SS).
4. Touch Enter.
9.4.2.4 Boost Operation Description
Manual Boost can be cancelled at any time by touching BOOST or STOP buttons.
Table 9-3 Manual Boost Operational Description
Manual
Time
Delay
Time
Remote
Time
Input
Mode
Operation - BOOST Button Select
0:00:00 ---- ---- ---- System enters Boost indefinitely.
X:XX:XX ---- ---- ---- System remains in Boost until the timer expires.
Table 9-4 Remote Boost Operational Description
Manual
Time
Delay
Time
Remote
Time
Input
Mode
Operation - Boost Button Select
---- 0:00:00 0:00:00 Trigger System will not enter Boost since no timers are set.
---- 0:00:00 X:XX:XX Trigger System immediately enters and remains in Boost
until the timer expires.
---- X:XX:XX X:XX:XX Trigger System delays for specified time and then enters
Boost until the timer expires.
---- X:XX:XX 0:00:00 Trigger System delays for specified time and then enters
Boost indefinitely.
---- 0:00:00 0:00:00 ON/OFF System enters Boost until the input signal is not
active.
---- 0:00:00 X:XX:XX ON/OFF System enters Boost until the input signal is not
active or the timer expires.