Enabling or Disabling the Mold Setups Screen 71
User Guide v 1.4 — September 2015 System Setup and Customization
To select the zone parameters to display:
1. On the Customize screen, touch the parameter button. The button toggles the setting
between YES and NO.
If the PID/ART parameter has been set to No, then the P, I and D settings in the Quick Set
screen are turned off as well. If PID/ART parameter is set to Yes, the P, I and D settings are
turned On.
NOTE:Use the Next Page button to access the remote standby (R. STDBY) and remote
boost (R. BOOST) parameters.
2. Touch OK to return to the Advanced Setup screen.
9.3.2 Enabling or Disabling the Mold Setups Screen
The MOLD SETUPS button enables or disables the access to the Mold Setup screen on the
system. The button on the Home screen will be greyed out.
Additionally, this setting overrides the boot-up sequence and automatically sets the Load
Last Mold Setup feature to On.
To enable or disable the Mold Setup screen:
1. On the Customize screen, touch MOLD SETUPS. The button toggles the setting
between YES and NO.
2. Touch OK to return to the Advanced Setup screen.
9.3.3 Enabling or Disabling the Security Screen
The SECURITY button enables or disables the access to the Security screen on the system.
The button on the Home screen will be greyed out.
Additionally, this setting overrides the boot-up sequence and removes security from all zone
parameters and settings in the system.
To enable or disable the Security screen:
1. On the Customize screen, touch SECURITY. The button toggles the setting between
YES and NO.
2. Touch OK to return to the Advanced Setup screen.
9.3.4 Assign to Basic
Touch ASSIGN TO BASIC, to assign the user defined zone parameter settings to the Basic
button in the System Setup screen. If selected, anytime a user puts the system in Basic mode,
the available zone parameters will reflect what was assigned to the Basic button from this
screen.
To Next Page
Loading...
