User Guide v 1.4 — September 2015 Mold Setups
31
Chapter 6 Mold Setups
Depending on how the system is configured (Refer to Chapter 5–Security), touching the OK
button in the Security screen will display the Mold Setup screen. In this screen allows the
operator to choose from 24 individual mold setups to heat up your mold. If this screen is not
configured to be displayed on power up, then it can be accessed from the Home Screen.
Figure 6-1 Mold Setup Screen
Function Description
LOAD Touch this button to load the highlighted mold setup into the system.
You must have a mold setup loaded before you can heat up the mold.
DEFAULT Touch this button and it will return all settings on the highlighted mold
setup to the default values. For safety reasons the system will not allow
the presently loaded mold setup to return to default values.
COPY Touch this button to make a copy of an existing mold setup in a different
location.
PASTE Touch this button to copy the existing mold setup in a different location.
NAME Touch this button to name or rename a mold setup. The maximum
number of characters allowed is 10.
OK Touch this button to exit out of the Mold Setup screen.
To Next Page
Loading...
