User Guide v 1.4 — September 2015 Security
25
Chapter 5 Security
The System can be configured to display the Security screen when the system is powered up
(Refer to Section 9.2.7) or bypassed. If this screen is not configured to be displayed on power
up, then it can be accessed from the Home Screen.
From the Security screen, the appropriate security code must be entered to gain access to
operate the system.
All system functions are listed on this screen along with the required security code needed
to adjust them.
Figure 5-1 Security Screen
Button Description
ENTER PSWD Touch this button to enter a password.
CHANGE LVL1 Touch to change the password for level 1. You must know the present
level 2 password to do this.
CHANGE LVL2 Touch this button to change the password for level 2. You must know
the present level 2 password to do this.
OK Touch this button to exit out of the Security screen.
0 Touch this button to change the selected function to security level 0.
To Next Page
Loading...
