Boost Timers 75
User Guide v 1.4 — September 2015 System Setup and Customization
Remote Standby can be cancelled at any time by touching the STANDBY or STOP buttons.
9.4.2 Boost Timers
To increase the temperatures in the mold for a certain period of time, the Boost timers
associated with each boost function can be set. Once the system enters boost, the timer will
start. When the timer finishes, the temperatures will return to the normal setpoint.
9.4.2.1 Setting the Manual Boost Timer
Once the system is in manual boost the manual boost timer starts to count down. When the
time limit is over the system will return to run mode.
To set the manual boost timer:
1. On the Home screen, touch TIMERS.
2. Touch MANUAL BOOST TIMER.
3. Enter the new timer value (HH:MM:SS).
4. Touch Enter.
9.4.2.2 Setting the Remote Boost Timer
The Input Option settings determine how the system reacts when it receives Remote Boost
input.
NOTE:If the system is not equipped with Remote Boost, only the Manual Boost timer
setting is displayed on the Timers screen.
To set the remote boost timer:
1. On the Home screen, touch TIMERS.
2. Touch REMOTE BOOST TIMER.
3. Enter the new timer value (HH:MM:SS).
4. Touch Enter.
---- X:XX:XX 0:00:00 ON/OFF ---- System delays for specified time and
then enters Standby until the input
signal is not active.
---- ---- ---- Direct ---- System enters Standby until the input
signal is not active. If the input signal is
active when the system is started, it
will immediately go into Standby
mode.
Table 9-2 Remote Standby Operational Description (Continued)
Manual
Time
Delay
Time
Remote
Time
Input
Mode
Cycle
Enabled
Operation - STANDBY Button
Select
To Next Page
Loading...
