Alarms and the Error Log 77
User Guide v 1.4 — September 2015 System Setup and Customization
Remote Boost can be cancelled at any time by touching BOOST or STOP buttons.
9.5 Alarms and the Error Log
Neo2 Alarms Status screen allows the operator to view the status of each zone and reset any
alarms that occur in the system.
9.5.1 Viewing Alarms
To view alarms:
1. On the Home screen, touch ALARM STATUS.
---- X:XX:XX X:XX:XX ON/OFF System delays for specified time and then enters
Boost until the input signal is not active or the
timer expires.
---- X:XX:XX 0:00:00 ON/OFF System delays for specified time and then enters
Boost until the signal is not active.
---- ---- ---- Direct System enters Boost until the input signal is not
active. If the input signal is active when the system
is started, it will immediately go into Boost mode.
Table 9-4 Remote Boost Operational Description (Continued)
Manual
Time
Delay
Time
Remote
Time
Input
Mode
Operation - Boost Button Select
To Next Page
Loading...
