v 1.4 — September 2015 Altanium Neo2
18 USB Port
3. To go back to Basic mode, touch BASIC ADV.
4.3 USB Port
The USB port on the Neo2 is intended to be used to copy mold setup files to and from the
system and to print information to a file. The screen for importing or exporting mold setups
is displayed only if a user inserts a USB disk into the USB port while in the Mold Setup Screen.
These mold setup files can be copied to other Altanium controllers that support the same file
type. The Print screen is an area where a user can print important reports directly to a USB
disk in a text file format. Refer to Section 4.4 for information on reports.
Figure 4-2 System Setup Screen - Basic Mode
1. BASIC ADV button
CAUTION!
Mechanical hazard - risk of damage to the unit and data integrity.
• Never power on with a device in the USB port.
• Never connect more than one memory device at a time.
• Never connect a powered hub or other device to the USB port.
• Removing the USB disk from the system during a read or write operation could
cause data corruption to the USB disk contents that could result in bad files or the
entire drive from being usable.
To Next Page
Loading...
