User Guide v 1.4 — September 2015 System Options
Altanium/Neo2 Optional Components 85
Chapter 11 System Options
The Altanium/Neo2 has a host of optional features available for an additional cost to assist
you in your molding process.
11.1 Altanium/Neo2 Optional Components
Software settings for the system options are available in the OPTIONS menu.
11.2 Integrated I/O
The integrated I/O are internal to Neo2 and managed through the operator interface.
11.2.1 Integrated I/O Option (Inputs)
The table below provides a description of the inputs that are included with the Integrated I/O
option. To activate any input, all that is required is the closure of two contacts on the Input
connector. Refer to Table 11-3 for connection details.
Integrated I/O This includes 3 inputs and 3 outputs that are internal to the Neo2
enclosure and managed through the system's operator interface. The
available functionality is fixed as follows:
Inputs: R. Standby, R. Boost and R. Stop
Outputs: At-Temperature, Abort (PCM) and Alarm Error
Altanium I/O Box This is an external box that enables the use of additional inputs and
outputs that are not supported using the integrated I/O. This option is
available in user definable packages of two, four and All.
SPI Communication The SPI option enables the Neo2 to communicate with any central
network or molding machine that supports the Society of Plastics
Industry (SPI) standard protocol.
To Next Page
Loading...
