Enabling or Disabling Auto Slave Function 67
User Guide v 1.4 — September 2015 System Setup and Customization
9.2.3 Enabling or Disabling Auto Slave Function
The AUTO SLAVE button sets the auto slave function for the system. If auto slave is set to No,
it does not affect the ability to manually slave zones.
To enable or disable the autoslave function:
1. On the Advanced System Setup screen, the AUTO SLAVE button displays the setting.
2. Touch AUTO SLAVE to toggle the setting between YES and NO. The default setting is
YES.
9.2.4 Setting the Global Power Limit
The GLOBAL PWR LIMIT button sets the Power Limit for the system. This setting overrides
any individual power limit setting for a zone if the individual setting is higher than the global
power limit.
To set the global power limit for the system:
1. On the Advanced System Setup screen, touch GLOBAL PWR LIMIT. The numerical key
window appears.
2. Enter the value for the power limit. The default setting is 100%.
3. Touch Enter.
9.2.5 Setting the Forced Bake Out Time
Forced bake-out is primarily used with cards that do not have current measurement
capability (XL-Series cards as indicated by a black colored heat sink). In this case, the ability
to detect a earth leakage does not exist and as a result the automatic wet-heater bake out
detection will not work. However, if the mold is running in a humid environment or it is felt
Figure 9-6 Numerical Key Window
1. Enter Button
To Next Page
Loading...
