Entering a Mold Name 33
User Guide v 1.4 — September 2015 Mold Setups
5. Enter the mold setup name and the touch Enter.
You will notice the time and date will be copied to the new location but the mold name
will not. This is done so you will have some way to distinguish between the original and
the copied setup.
6.4 Entering a Mold Name
To help in identifying different mold setups the Neo2 allows mold setups to be assigned a
name.
NOTE:Make sure the present security level is allowed to make this change.
To enter a mold name:
1. On the Mold Setup screen, touch the Mold Setup number to select the mold setup file
you want to name. Mold setups names are allowed a maximum of 10 characters.
2. Touch NAME and the Keyboard window appears.
3. Enter the name for the mold. A maximum of 10 characters are allowed.
4. Touch Enter. The name will now be stored in the NAME column in the location you
selected.
Figure 6-2 Keyboard Window
1. Enter Button
To Next Page
Loading...
