Page 111
User Guide v 1.0 — August 2018 Altanium Neo5
10.2 Changing the Number of Zones in the System
You may need to add or remove zones to an existing mold setup. If the mold running has
fewer control zones than listed on the screen, you can remove the unused zones to make
sure they are not displayed.
To change the number of zones in the system, do the following:
1. On the Home screen, touch .
2. Select the number of zones and/or slots to be enabled or disabled.
3. Touch the Slot Enable button.
4. Touch .
5. Restart the controller.
To Next Page
Loading...
