v 1.0 — August 2018 Altanium Neo5
Page 39
Chapter 7 Making Adjustments
You can make adjustments to the process settings for a mold setup before starting the mold,
or while the mold is running. This chapter explains how to use, monitor and modify the
system.
Neo5 allows zone data to be displayed in different graphical and textual formats. These
include tabular views, images, and views that are divided into groups of zones.
7.1 Zone Selection
Multiple zones can be selected from the following screens:
• Multi-Group View
• Text View
• Quick Set
• Neo2 View
• Staging
• Mold Test
• Mold Test Results
• Zone Calibration
• Zone Slot Configuration
• CAN Info
1. You can select zones four ways:
a. Touch a zone. The zone is selected.
b. Touch . This selects all the available zones.
c. Use the Block function. Touch and hold a zone element for more than a second. This
will highlight the zone green. Then touch another zone. All the zones between the
start and end zone are highlighted (selected).
d. Touch a zone and drag your finger. All the zones that your finger passes over are
selected. This is a zone selection option on all the screens except the Neo2 view.
2. Touch to reset all the selected zones.
3. When a zone is selected it will turn yellow.
To Next Page
