v 1.0 — August 2018 Altanium Neo5
Page 108
System Setup Screen Item Descriptions
Item Description
Serial Number The Serial Number is for informational purposes only. It is a
number assigned to the system when it is manufactured. Husky
support may ask for this number when troubleshooting or
upgrading.
Model Controller model name.
Company Name User definable company name displayed in the system header.
Software Version The Current Software Version is for informational purposes only.
Husky support may ask for this number when troubleshooting or
upgrading.
Auto Save Mold Setup If checked, all changes to the current mold setup will be saved as
they occur and cannot be discarded.
Allow Monitor Regulation for
Selection
Enables the parameter that allows the change of the regulation
mode to “Monitor” for zones in the Quick Set screen.
Exclude Monitor Zones from
At-Temperature
Enables the parameter that allows the exclusion of the zones set
to “Monitor” regulation from the at-temperature determination
by the system.
Force Phase Angle Control There are two methods for controlling the power applied to the
heaters, refer to Section 2.2. If checked, only the phase angle
control will be used.
Show Temperature For
Manual Zones
A global setting that controls whether the controller view screens
display the thermocouple readings for zones in manual mode.
To Next Page
Loading...
