Page 83
User Guide v 1.0 — August 2018 Altanium Neo5
ART
• Reset — Resets the ART parameters for the zones. At the next start operation, the zones
will go through the ART process.
NOTE: Reset can be selected regardless of the system mode.
• Re-ART — Reruns the tuning process on the selected zones.
NOTE: The system must be in run mode before a zone can be Re-ARTed.
• Cancel — Stops the ART process.
NOTE: The system must be in run mode before the ART process can be canceled.
To Next Page
Loading...
