1-3
Scanner Assembly
032-0330-EN Rev K
6.
6
When seated properly, overhead locks into
place. To ensure safety, the overhead should
still be supported by an assistant until
mounted.
7.
3/16
7
From rear of scanner, secure overhead with
mounting hardware, two SHCS1/4-20 x 5/8
long with 1/4” split washers, both sides.
8.
11
9
10
The scanner must be checked for squareness
prior to installing the mounting hardware at the
top of the overhead.
9. Hook a tape-measure on bottom rear edge of
scanner, as shown.
10. Run the tape diagonally to the upper open
corner, as shown and record the
measurement.
Measurement should be approximately 65-3/8”
[166cm].
11. Take the same measurement on the opposite
corners and record measurement.
The two measurements must be identical
+ 1/16” [1.6mm].
If measurements are not within tolerance, push
the top of the scanner to the right or left and
remeasure.
To Next Page
Loading...
